Plug-In Enabler Info

The PLUG-IN ENABLER allows you to determine which Plug-Ins you want to use with Logic.

On the left hand side of the window you can see all Plug-Ins used by Logic Audio, in the right hand side those which are not used. You can change these settings at any time by selecting a Plug-In and clicking on the corresponding button. Logic will always check these settings during start up.

Attention: It is not possible to change any setting while Logic is running.

Furthermore, PLUG-IN ENABLER tests all Plug-Ins. This is very important as we found during extensive tests that some Plug-Ins may cause problems and might even crash.

If you experience a crash after booting the PLUG-IN ENABLER, it is very probable that this was caused by a Plug-In. Please re-boot the PLUG-IN ENABLER again after such an incident. The trouble-maker will automatically be disabled and the test will continue.

If you try to re-activate a problematic Plug-In, you will be warned that this might cause trouble. If the problems do not exist any more, e.g. after installing an update of the Plug-In, you may re-activate the Plug-In.

By far the most Plug-Ins we tested ran without any problems. In addition, we continuously cooperate with all Plug-In vendors to improve - if possible - the quality of the Plug-In support in Logic Audio.